Settings change for BVN (Bluejay / Nfusion/ Satcruiser)
03/01/2015 09:26Likely due to a transponder issue the settings on your BVN satellite receiver need to be changed in order to watch BVN again.
For most receivers on the BVN satellite remote follow these instructions:
-press "Menu"
then
-arrow down(4 times) to select "installation"
then
-arrow down (2 times) to select "TP configuration"
then
-arrow down (6 times) to change frequency from 12080 to 12089
then
-change symbol rate from 25.635 to 11.719
then
-arrow down 1 more time and exit out of the install menu.
Don't change any of the other settings.
After a minute BVN should be there. In some cases it might be necessary to power toggle (switch on the back) the receiver.
———
Back